Professional publications about FIPFG
"The foamy fillers"
from: Festo KG, issue 1/2010, page 32
Text: Festo KG
They are small, they can be found almost everywhere, but generally no one pays any attention to them: foam seals. However, they provide reliable protection against air, dust and moisture. CeraCon’s new 1-component system, produced using proportional technology, is bringing innovation to the seals industry...
ceracon_fipfg_technical_report_trends_in_automation_01-2010.pdf
"Tight automobile doors"
from:: ABB website
Text: ABB Ltd.
Another challenge was pairing the short cycle time with the high utilization of the system. A sealed door module must leave the system every 15 seconds for a minimum of five days per week within a three-shift operation. The special properties of the Penguin Foam sealing foam were important here also...
ceracon_fipfg_technical_report_abb-plastics-automation_07-2006.pdf
"Foamed seals in one-component polyurethane"
from: PU-Magazine, issue 02/2005, page 93-94
Text: CeraCon GmbH
The Penguin foam system with the Foamply application technology produces foamed seals in one-component elastomers directly onto the component to be sealed (FIPG sealing technology = formed in-place gaskets). Complex seal shapes can also be achieved...
ceracon_fipfg_technical_report_pu-magazine_02-2005.pdf
"Boat trims at Holmgrens Plast, Sweden"
from:: ABB website
Text: ABB Ltd.
Holmgrens, a Swedish injection mouding specialist, has 10 robotized production cells, of which four feature 6-axis systems from ABB. Production is run around the clock, seven days a week. Today, Holmgrens works in many markets. The investment in two robotized cells that make plastic trolley boards...
ceracon_fipfg_technical_report_abb-plastics-automation_10-2005.pdf
